01
Check the radio receiver for damage.
| The radio receiver is damaged | ➔ | Remove the radio receiver from the system. The radio receiver must be returned to the local supplier for repair. Go to Deploy spare radio receiver. |
| The radio receiver is not damaged | ➔ | Go to Step 2 |
02
Switch on the calibration module and check on the EXCON whether the radio receiver is still receiving a signal from the calibration module.
Make sure all cables are properly connected.
03
Slide the tripod back up and re-measure the field according to the instructions in Measure Training Field.
04
Insert the measured data again according to instructions in Read measured data. The positioning system is now working again.